Billy Goat FM3300 User Manual (English)

Questions and Answers:

A
Alexis Williams MDSep 6, 2025
Why Billy Goat Lawn Mower engine will not start?
- D
  david84Sep 6, 2025
  Your Billy Goat Lawn Mower engine may fail to start due to several reasons. It might not be properly primed, so prime to choke. Alternatively, the gasoline may be old or you might be out of gasoline, so check gasoline. Check for spark with an approved tester if the spark plug wire is disconnected. A dirty air cleaner can also be the culprit, so clean or replace the air cleaner. Lastly, ensure the Blade Clutch is disengaged by disengaging the Blade Clutch Lever.
R
Raymond ThompsonSep 7, 2025
What to do if my Billy Goat Lawn Mower will not cut or has poor cutting performance?
- A
  Anthony WallaceSep 8, 2025
  If your Billy Goat Lawn Mower isn't cutting well, the blade might be dull or bent, so sharpen or replace it. Another cause may be a clogged deck, so unclog the deck. Also, make sure the engine isn't running at too low RPM, and avoid mowing wet grass, wait until it's dry. If the grass is excessively high, mow once at a high cutting height and then again at the desired height, or make a narrower cutting path.
K
kdavisSep 9, 2025
What to do if my Billy Goat Lawn Mower engine runs poorly?
- D
  Darrell LucasSep 9, 2025
  If your Billy Goat Lawn Mower engine is running poorly, it could be due to several reasons. A loose spark plug wire can cause this, so check it. Also, the engine RPM might be set too low. Water or dirt in the fuel system can also lead to poor performance, so drain or siphon the fuel and replace it with fresh gasoline. Lastly, a fouled, faulty, or wrongly gapped spark plug can be the issue, so reset the gap or replace the spark plug.
S
Steven ThomasSep 12, 2025
Why is my Billy Goat Lawn Mower giving an uneven cut?
- O
  oriceSep 12, 2025
  An uneven cut from your Billy Goat Lawn Mower can be due to a couple of things. First, check that the height adjust is set the same on both sides. Also, a dull or bent blade can cause an uneven cut, so sharpen or replace the blade.
D
Donna MccannSep 12, 2025
Why Billy Goat Lawn Mower engine will not stop?
- T
  Tyler DavenportSep 12, 2025
  If your Billy Goat Lawn Mower engine won't stop, it could be due to a damaged control cable, in which case, replace the control cable. If you have an electric start model, the Harness Wire might be disconnected or damaged; reconnect it or replace it if necessary. A damaged ignition switch (for electric start models) could also be the reason, so replace the switch.
R
Rhonda StewartSep 14, 2025
What causes abnormal vibration in my Billy Goat Lawn Mower?
- A
  Albert FowlerSep 14, 2025
  Abnormal vibration in your Billy Goat Lawn Mower can stem from a few issues. The blade might be loose or out of balance, so check the blade mount and balance or replace it if needed. A bent blade can also cause vibration, so replace it with a new one. Finally, check the engine mount in case the engine is loose.