Only activated via the remote control: to change the unit of
measurement from Celsius (°C) to Fahrenheit (°F).
Only activated via the remote control and APP: to start or disable
movement of the louvers.
button
Activated via the remote control and APP: it reduces the fan speed (if
med/hi speed is set); this function is available in Cool and Heat modes.
The function is activated from the control panel by pressing the “FAN”
and “UP” buttons simultaneously. In this function the appliance will
operate in quiet, energy saving mode.
• Weekly programming (only activate via Smartphone): sets: the on/off periods for each
day of the week.
Window kit, comprising:
• extending flexible pipe (15x145)cm, (18): fit the circular fitting on one end and turn
it clockwise and do the same with the duct on the other end; when done, check that
the parts are rigidly fixed in place.
• adjustable window adapter (92-184)cm, (19):
- Use the Adjustable (sliding) Kit to close the
space left open by the windows. Composed
of: 1 plate with a hole (B), and 2 sliding plates
(A). To assemble the kit, proceed as described
(see the pictures opposite); the plate with a
hole: insert the screw with the "plate" head
from the inside into the hole, insert the
washer and wing nut from the outside
(opposite). Insert a sliding plate so that the
screw head fits into the central guide; after
adjusting the plates to the most suitable size,
then lock them by tightening the nut. If
necessary, also assemble the other sliding
plate at the opposite end as indicated above.
- Place the appliance as close as possible to a
window or glass door, keeping it at least 50
cm from walls or other nearby obstacles. It is
important to reduce exposure to direct
sunlight using rolling shutters, curtains or
Venetian blinds, and to keep doors and
windows closed. The pipe can be adjusted
from 40 cm up to a maximum of about
145cm; keep the pipe as short as possible,
and do not curve the flexible pipe too tightly
or create kinks in it. Do not use extension or
replacement pipes, as this might cause a
malfunction. The outlet must be
unobstructed; otherwise, overheating may
occur.
To Next Page
Loading...
