10/16
• Do not pull on the cord to disconnect the plug from the socket.
• If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
• Do not use the appliance with a timer or a programmer or with a system that
can switch on the appliance automatically, to avoid risk of fire, since a fire risk
exists if the appliance is covered or positioned incorrectly.
• If the appliance breaks down or there is a malfunction, switch off the appliance and
have it checked by qualified personnel; repairs carried out by unauthorised
personnel may be dangerous and invalidate the guarantee.
• After removing the packing materials, check the integrity of the appliance; if you are unsure, do not
use it and ask for qualified professional help. The packing materials (plastic bags, polystyrene foam,
nails, etc.) must be kept out the reach of children because they are potential sources of danger.
All packaging elements must be disposed of according to their raw material (see the symbol stamped
on each one) and according to the provisions of their municipality. The bag containing the base or
screws, which is unmarked due to its small size, therefore you have to follow the procedures for the
disposal of their municipality.
• Before connecting the appliance, check that the voltage values shown on the data plate correspond
to those of the electricity supply network. In the event of incompatibility between the electric outlet
and the plug of the appliance, have the outlet replaced with another more suitable type by
professionally qualified personnel, who will make sure that the section of the wires of the outlet is
appropriate for the absorbed power of the heater. In general, the use of adapters or extension cords
is not recommended; if their use is indispensable, they must conform to existing safety standards and
their current capacity (amperes) must not be less that the maximum of the appliance.
• The power socket must be easy to reach so the plug can be removed quickly in case of emergency.
• Before each use, check that the equipment is in good condition, and that the power cable is not
damaged: if in doubt consult a qualified professional.
• Place the appliance far from
- Heat sources (e.g.flames, gas stoves etc.)
- container of liquids (e.g.sinks etc) to avoid any spray or the appliance falling into it (minimum
distance of 2 meters)
- fabrics (curtains, etc.) or unstable materials that could obstruct the air intake grille; make sure
that the front is free of unstable materials (dust, etc.).
• The surface on which the appliance is placed must be stable, level (otherwise the unit may fall over)
and smooth. Do not place the fan on shelves. Do not hang the unit on the wall.
• This appliance is not intended to be operated by means of an external timer or a separate remote
control system, to avoid the risk of fire in case the device is covered or is positioned incorrectly.
• Do not place the wall fan into the room to avoid the back-flow of gases from the open flue of gas or
other fuel-burning appliances (for duct and partition fans).
To Next Page
Loading...
Need help?
General
