17/20
- Maximum speed (H) set: the fan will run at maximum speed for 30 minutes, then at medium speed
for 30 minutes and then will switch to low speed until the unit is turned off manually or by the timer
which has been previously set.
- Average speed (M) set: the fan runs at medium speed for 30 minutes, it changes to minimum speed
for 30 minutes.
- Minimum speed (L) set: the fan runs at minimum speed
To activate the constant speed mode, press the button again until the three speed icon appears on the
display: “L” or “M” or “H”.
-
Horizontal oscillation (right-left):
this is done by pressing button “OSC ” on the remote control
or the keypad. To stop the movement, press button (4) once again.
To turn the fan off press the “ ” button on the remote control or the control panel, then unplug the
plug from the mains.
If the appliance is not being used for long periods of time, remove the plug from the plug point.
CLEANING AND MAINTENANCE
Attention:
before normal cleaning, remove the plug from the socket.
• Clean the body with soft, slightly damp, cloth; do not use abrasive or corrosive products.
• Do not immerse any part of the fan in water or other liquid: if this should happen, do not put your
hand in the liquid, but first remove the plug from the socket. Carefully dry the appliance and make
sure that all the electrical parts are dry: in the case of doubt, ask for professionally qualified help.
• It is essential that the motor's air holes be kept from dust and lint.
• If the fan will not be used for long periods, it must be protected from dust and humidity; we
recommend storing it in its original packaging.
• Should you decide not to use the appliance any more, we recommend making it inoperative by cutting
the power cord (after making sure you have disconnected the plug from the socket) and make
dangerous parts harmless if children are allowed to play with them.
To Next Page
Loading...
