10/16
• If the electric cord is damaged, it has to be replaced by the supplier or an
authorized service center or a professionally qualified, to avoid any risks.
• Do not use the appliance with a timer or a programmer or with a
system that can switch on the appliance automatically, to avoid risk
of fire, since a fire risk exists if the applaince is covered or positioned
incorrectly.
• Ensure that the fan is switched off from the supply mains before
removing the guard.
• After removing the packing materials, check the integrity of the heater; if you are unsure, do
not use it and ask for qualified professional help. The packing materials (plastic bags,
polystyrene foam, nails, etc.) must be kept out the reach of children because they are potential
sources of danger.
All packaging elements must be disposed of according to their raw material (see the symbol
stamped on each one) and according to the provisions of their municipality. The bag
containing the screws or other parts, which is unmarked due to its small size, therefore you
have to follow the procedures for the disposal of their municipality.
• Before connecting the appliance, check that the voltage values shown on the data plate
correspond to those of the electricity supply network. In the event of incompatibility between
the electric outlet and the plug of the appliance, have the outlet replaced with another more
suitable type by professionally qualified personnel, who will make sure that the section of the
wires of the outlet is appropriate for the absorbed power of the appliance. In general, the use
of adapters or extension cords is not recommended; if their use is indispensable, they must
conform to existing safety standards and their current capacity (amperes) must not be less
that the maximum of the appliance.
• The power socket must be easy to reach so the plug can be removed quickly in case of
emergency.
• Do not place the fan on a shelf and/or near sinks or other container of liquids (minimum
distance of 2 meters) to avoid the risk of it falling in.
• Keep the fan far away from fabrics (curtains, etc.) or unstable materials that could obstruct the
air intake grille; make sure that the front is free of unstable materials (dust, etc.).
• This device is NOT suitable to use it in an explosive environment (in the presence of flammable
substances such as gas, vapor, mist or dust, in atmospheric conditions when, after ignition, the
combustion is spread in the air).
• Make sure that the electric cord is not touching rough, hot or moving surfaces and not twisted
or wrapped around the appliance.
• Stand the appliance on a horizontal, flat surface or table; do not stand on a inclined plane (the
appliance could upset).
• Do not place the appliance near an open flame, cooking or other heating appliance.
To Next Page
Loading...
Need help?
General
