EasyManua.ls Logo

Binatone BAC-201 - Cleaning and Maintenance; Cleaning Procedures; Maintenance Recommendations

Binatone BAC-201
19 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9
Instructions for Cleaning and Maintenance
Stretch button placements
Plug of water tank
5. Clean water tank. Take out the water tank and wipe it with soft cloth and detergent water and flush it with
clean water at last. Put it back when it is completely dried. ( Notes : 1. Don’t clean the water tank with
chemical solvent ( gasoline, etc. ), cleaning naphtha, corrosive detergent or solvent. 2. You can empty
the water tank by open the plug of water tank at the bottom of air cooler.)
6. Clean ice bag. Take out the ice bag and wipe it with soft cloth and detergent water and flush it with clean
water at last. (Notes: 1. Don’t clean the ice bag with chemical solvent (gasoline, etc.), cleaning naphtha,
corrosive detergent or solvent.
7. It is recommended to check the wet curtain and water tank regularly. If the wet curtain and water tank can
be kept in clean, the air cooler will be in the best operating state.
8. When the electric appliance is not used any more, please store it in a dry place with good ventilation after
cleaning.
1. Make sure that the plug is pulled out from the socket. Please make sure that the air cooler is completely
stopped before cleaning.
2. Don’t clean the air cooler with grinding sponge, scouring pad or hard brush.
3. To keep the air cooler clean, wipe the dirt by clean soft cloth with soap and water and then wipe dry the air
cooler. ( Notes: 1. Don’t clean the air cooler with chemical solvent (gasoline, etc. ) , cleaning naphtha,
corrosive detergent or solvent. 2. It is forbidden to flush or drench the air cooler. 3. Don’t beat the air
cooler with stick to clean dust.)
4. If you need to clean the wet curtain , take off the rear net from the main body and take out the wet curtain
from the rear net. Clean the wet curtain with detergent water . Clean the deep internal parts with soft brush.
Take care and don’t damage the wet curtain. Flush the wet curtain with clean water and then install it back to
the rear net after it is completely dried. ( Notes: stretch the button placements of wet curtain at the rear
net towards the two sides when you take out the wet curtain to avoid damage due to scratch.)