5
Instructions for Usage
1. Please connect the air cooler into the 220-240
V AC 50Hz power source and start the power
switch. The electric appliance will enter into the
ready mode with a “ beep ”. The “ ON / OFF ”
indicator light will be in red.
The water
level must be
in the min.
indicatrix at
least
The water pump
holder must be pulled
out
2. Press “ON/OFF” button to start air cooler and
press the button again to close it . When the air
cooler starts up , it is in the highest speed level
of “ 4 ” in default. The corresponding indicator
light will be ON.
Speed level display:
3. Press speed button to select the speed level. (Notes:
the speed level is displayed by the number of lights.
In the highest speed level of “4”, all the 4 lights will
be ON ; in the high speed level of “3”, all the 3 lights
will be ON; in the medium speed level of “2”, both the
2 lights will be ON; in the low speed level of “1”, the 1
light will be ON.)
4. Press cooler button to start the humidification function;
the cooler indicator light will be ON and the water pump
starts to work . When the wet curtain is drenched,
humidified wind will be generated . Press the cooler
button again to close the function and the cooler indicator
light will be OFF. ( Notes : (A) Before starting
humidification function, make sure that there is water
in water tank ( at least above the min. water level
indicatrix). If the water in the water tank is lower than
the min. water level indicatrix, the cooler indicator
light will flicker and the humidification function will
be automatically stopped after a “beep” sound by air
cooler. (B) Before starting humidification function,
make sure that the water pump holder reach the
water.
Press this button to start air cooler.
The indicator
light is ON
Speed button
Level 1Level 2Level 3Level 4
Cooler Button
Red light ON
To Next Page
Loading...