2
© ITW FINISHING SYSTEMS AND PRODUCTS
READ THE MANUAL
Before operating finishing equipment, read and understand all
safety, operation and maintenance information provided in the
operation manual.
GET IMMEDIATE MEDICAL ATTENTION
To prevent contact with the fluid, please note the following:
a) Never point the gun/valve at anyone or any part of the body.
b) Never put hand or fingers over the spray tip.
c) Never attempt to stop or deflect fluid leaks with your hand, body
glove or rag.
d) Always have the tip guard on the spray gun before spraying.
e) Always ensure that the gun trigger safety operates before spraying.
f) Always lock the gun trigger safety when you stop spraying
READ THE MANUAL
All personnel must be trained before operating finishing
equipment.
EQUIPMENT MISUSE HAZARD
Equipment misuse can cause the equipment to rupture,
malfunction, or start unexpectedly and result in serious injury.
MEDICAL ALERT
Any injury caused by high pressure liquid can be serious. If you are
injured or even suspect an injury;
a) Go to an emergency room immediately.
b) Tell the doctor you suspect an injection injury.
c) Show the doctor this medical information or the medical alert card
provided with your airless spray equipment.
d) Tell the doctor what kind of fluid you were spraying or dispensing.
e) Refer to the Material Safety Data Sheet for specific information.
DE-ENERGIZE, DEPRESSURIZE, DISCONNECT AND
LOCK OUT ALL POWER SOURCES DURING
MAINTENANCE
Failure to De-energize, disconnect and lock out all power
supplies before performing equipment maintenance could
cause serious injury or death.
HIGH PRESSURE CONSIDERATION
High pressure can cause serious injury. Relieve all pressure
before servicing. Spray from the spray gun, hose leaks, or
ruptured components can inject fluid into your body and cause
extremely serious injury.
WEAR RESPIRATOR
Toxic fumes can cause serious injury or death if inhaled. Wear a
respirator as recommended by the fluid and solvent manufacturer’s
Material Safety Data Sheet.
PRESSURE RELIEF PROCEDURE
Always follow the pressure relief procedure in the equipment
instruction manual.
TOXIC FLUID & FUMES
Hazardous fluid or toxic fumes can cause serious injury or death if
splashed in the eyes or on the skin, inhaled, injected or swallowed.
LEARN and KNOW the specific hazards or the fluids you are using.
KEEP EQUIPMENT GUARDS IN PLACE
Do not operate the equipment if the safety devices have been
removed.
FIRE AND EXPLOSION HAZARD
Improper equipment grounding, poor ventilation, open flame or sparks
can cause hazardous conditions and result in fire or explosion and
serious injury.
AUTOMATIC EQUIPMENT
Automatic equipment may start suddenly without warning.
PROJECTILE HAZARD
You may be injured by venting liquids or gases that are released under
pressure, or flying debris.
INSPECT THE EQUIPMENT DAILY
Inspect the equipment for worn or broken parts on a daily
basis. Do not operate the equipment if you are uncertain about
its condition.
ELECTRIC SHOCK / GROUNDING
Improper grounding or sparks can cause a hazardous condition and
result in fire, explosion or electric shock and other serious injury.
NEVER MODIFY THE EQUIPMENT
Do not modify the equipment unless the manufacturer
provides written approval.
PINCH POINT HAZARD
Moving parts can crush and cut. Pinch points are basically any areas
where there are moving parts.
KNOW WHERE AND HOW TO SHUT OFF THE EQUIPMENT
IN CASE OF AN EMERGENCY
NOISE HAZARD
You may be injured by loud noise. Hearing protection may be required
when using this equipment.
STATIC CHARGE
Fluid may develop a static charge that must be dissipated
through proper grounding of the equipment, objects to be
sprayed and all other electrically conductive objects in the
dispensing area. Improper grounding or sparks can cause a
hazardous condition and result in fire, explosion or electric
shock and other serious injury.
PROP 65 WARNING
WARNING: This product contains chemicals known to the State of
California to cause cancer and birth defects or other reproductive harm.
WEAR SAFETY GLASSES
Failure to wear safety glasses with side shields could result in
serious eye injury or blindness.
IT IS THE RESPONSIBILITY OF THE EMPLOYER TO PROVIDE THIS INFORMATION TO THE OPERATOR OF
THE EQUIPMENT.
FOR FURTHER SAFETY INFORMATION REGARDING BINKS AND DEVILBISS EQUIPMENT, SEE THE
GENERAL EQUIPMENT SAFETY BOOKLET (77-5300).
WARNING
CAUTION
NOTE
Hazards or unsafe practices which
could result in severe personal
injury, death or substantial property
damage.
Hazards or unsafe practices which
could result in minor personal injury,
product or property damage.
Important installation, operation or
maintenance information.
Read the following warnings before using this equipment
In this part sheet, the words WARNING, CAUTION and NOTE are used to emphasize important safety information as follows:
To Next Page
Loading...
