bintec elmeg be.IP swift Quick Start

4.5.2
Parts and accessories
Your device is provided with all parts and accessories required to perform its intended functions. The delivery includes:
•
the device itself
•
all cables required for initial installation
•
a power supply unit if no internal power supply is installed
•
Wi-Fi antennas
•
GSM/4G antennas if the device is equipped with an internal GSM/4G modem.
•
installation instructions
•
security and conformity information (this document)
bintec elmeg devices does not require any additional software to perform the intended functions. The software installed
has been tested to support all intended functions and is updated on a regular basis to maintain security and full operation.
Only original software provided by bintec elmeg GmbH can be installed on the device. The software provides procedures
to update itself either over the Internet or by a locally stored file. The software must be kept up to date in order to maintain
the security and conformity of the device across future changes of the applicable directives.
4.5.3
Radio characteristics
In accordance with Article 10(8) of the Radio Equipment Directive 2014/53/EU, the following lists provide information on
frequency bands and RF transmit power levels.
Devices according to 802.11a/n
The permitted transmission power may vary in countries outside the EU.
•
2.400 - 2.4835 GHz - max. 20 dBm / 100 mW
•
5.150 - 5.250 GHz - max. 23 dBm / 200 mW
•
5.250 - 5.350 GHz - max. 20 dBm / 100 mW
•
5.470 - 5.725 GHz - max. 27 dBm / 500 mW
Devices according to 802.11ac / 802.11ax supporting TPC
The permitted transmission power may vary in countries outside the EU.
•
5.150 - 5.350 GHz - max. 23 dBm / 200 mW
•
5.470 - 5.725 GHz - max. 30 dBm / 1000 mW
Devices supporting 2G / 3G / 4G
GSM, GPRS (2G)
GSM, GPRS Frequency Range Transmitted Power
EGSM(900) Tx: 880–915 MHz GMSK: Class 4, 33 dBm max
8PSK: Class E2, 27 dBm max
DCS(1800) Tx: 1710–1785 MHz GMSK: Class 1, 30 dBm max
8PSK: Class E2, 26 dBm max
WCDMA (3G, UMTS)
UMTS Frequency Range Transmitted Power
Band 1 (2100) Tx: 1920–1980 MHz Class 3, 24 dBm max
Band 8 (900) Tx: 880–915 MHz Class 3, 24 dBm max

bintec elmeg be.IP swift Specifications

General

Brand	bintec elmeg
Model	be.IP swift
Category	Network Router
Language	English