4.
Pausing and Resuming During Exercise
When the user has been exercising, time is counting up or down, total steps, distance and
calories are accumulated. If the user stops exercising, the active calculations stop but are
not cleared and the lower window stops scrolling through for a period of 60 seconds.
When the user starts to exercise again, everything resumes from where it stopped if it is
under 1 min.
Clearing Settings
There is no Clear button to reset the effort level, time and weight to default values or
reset the accumulated cycles, total work, and calories to zero. The user can use the Start
/ Pause button to look at the accumulated values of total cycles, total work and calories
60 seconds after the user stops pedaling if no other buttons are hit, or 60 seconds after
the last button is hit, all items reset to the original default values.
Display Shut Down
Two minutes after the user stops exercising or the last button is pressed, the display
shuts off, plugged into the power supply or not. The user must start exercising to turn
it back on.
NOTE: An explanation of METs, and the relationship of calories burned to oxygen
consumption and METs, is provided in the Clinical Considerations section.
NOTE: It is possible to turn OFF the “beep” that sounds as parameters scroll
during exercise: See changing configuration settings.
— 9 — OPERATION AND DISPLAY SETTINGS
To Next Page
Loading...
