What to do if my Bionic ComfortLine moves slowly and then stops?
If your Bionic Medical Equipment is moving slowly and stops, it could be due to a lack of mains voltage, causing the equipment to run on battery power, and the emergency battery may be discharged. Check the mains voltage, ensure the mains plug is properly connected, and replace the battery.
How to troubleshoot a Bionic Medical Equipment that is not working?
If your Bionic Medical Equipment is not functioning, several issues could be the cause. First, check the power supply, including the fuse and mains voltage. If those are fine, try replacing the battery and checking the on/off switch. Also, make sure the DIN connector is properly connected. If the issue persists, the fuse on the board may be defective, requiring replacement, or the power transformer may be faulty, necessitating control replacement.
General| Brand | Bionic |
|---|---|
| Model | ComfortLine |
| Category | Medical Equipment |
| Language | English |
Remove the transport safety device and cable tie before use.
Insert the head segment into the back of the back segment.
Intended use for Bionic therapy chairs under medical supervision.
Set the shock position using the foot switch for faster motor speed.
Activate the central brake to lock all four wheels securely.
Perform functional checks on all chair drives to their end positions.
Troubleshooting steps for when the chair fails to move.
Troubleshooting steps for slow movement or sudden stops.
Troubleshooting steps for intermittent motor operation.
Troubleshooting for when a single motor fails to operate.
Troubleshoot issues with the foot pedal for shock position.
To Next Page