5/20 v2 03-13-2020
ASSEMBLING YOUR METAFLY
Legs, wings, tail and rudder must be assembled to
MetaFly’s body. It is very simple if you follow strictly
the instructions below but might be tricky if you don’t.
Please proceed with care as all parts are tiny, and make
sure you wear your reading eyeglasses (if needed).
1/ LEGS
1 - Slide the “hook” at the end of the leg below the screw
head (the screws come already assembled on the
frame).
2 – When it’s in the right position, fix it by tightening the
screw (use the supplied screwdriver).
2/ TAIL
This require more attention, please follow strictly this 3
steps process:
To Next Page
Loading...