RL39 - Repair instructions for changing the frame
Version 1.0, last revised 03/2016
10/58
H. Removing the kickstand plate
Undo the four bolts of the kickstand plate using a size 5 Allen wrench and
remove it together with the kickstand.
I. Removing the inner bearing
Carefully pull the rectangular connector out of the frame and unplug the
connector. To do this, press in the locking clip using your fingernail to undo
the catch on the connector.
The inner bearing tool has only a short insertion depth in the bearing shells. When installing/ removing the
bearing shells, always exert an axial pressure on the tool in order to prevent it from slipping and causing damage.
The smart ebike has an inner bearing which can be adjusted in the axial direction by means of spacer rings. This
allows the line of the belt to be corrected. The line of the belt is set correctly at the factory, but it may need to be
adjusted if parts of the drive system have been replaced.
Remove the seals on both sides of the inner bearing from the axle.
To Next Page
Loading...
