To Next PageTo Next Page
Need help?Do you have a question about the BIOPAC Systems, Inc. MP150 and is the answer not in the manual?
General| Type | Data Acquisition System |
|---|---|
| Input Range | ±10 V |
| Resolution | 16-bit |
| Common Mode Rejection Ratio | >100 dB |
| Channels | 16 |
| Sampling Rate | Up to 400 kHz aggregate |
| Communication Interface | USB |
| Weight | 5 lbs |
Details the components included in the MP150 starter system.
Describes the UIM100C as the interface between MP150/100 and external devices.
Step-by-step guide for setting up software for TSD109 calibration.
Describes the DA100C as a single-channel differential amplifier for various transducers.
Steps for calibrating the transducer using the physical variable.
Provides instructions for setting up the TSD107B hardware.
Options for calibrating the TSD117 transducer without a syringe.
Describes the features and capabilities of the 100C series modules.
Details the controls and functions of the DTU100 Digital Trigger Unit.
Instructions for setting up SKT100C for temperature measurements.
Introduces the O2100C and CO2100C gas analyzers.
Steps for setting up the gas sampling system for calibration.
Describes the OXY100C for measuring blood oxygen saturation and pulse rate.
Describes the control unit for the micro pressure measurement system.
Describes the STM100C as a single channel stimulation amplifier.
Highlights critical safety information for stimulus isolation units.
Describes the TEL100C system for remote monitoring.
Lists the specifications for the BAT100 rechargeable battery pack.
Critical safety guidelines for MEC series cables.
Describes the HMD1 and HMD2 head-mounted displays.
Lists the specifications for the HDS100 haptic delivery system.
Lists the specifications for the SDS100 scent delivery system.
Details the specifications for the eye tracking system.
