7
Troubleshooting
1. Power light not lit. Check the following:
- is the unit turned on?
- is the unit plugged in?
- is the electrical outlet working?
2. Lamp indicator light not lit. Check the following:
- is the unit turned on and the fan working?
- is the lamp connector securely attached?
- is it time to replace the lamp?
(See “Maintenance” section)
3. Low air flow. Check the following:
- is the fan input or output obstructed?
4. Power Light Flashes Red Check the following:
- Electrical Fault, Service Required
- Unplug the unit from the electrical outlet for 10
seconds and then plug into outlet again.
- If Power LED continues to flash RED, replace lamp or
contact BioZone for service
Specifications
Purification Method: Photoplasma / Photochemistry
Treatment Area: (See “Range Specifications” section)
Ozone Output: Accumulation will not exceed 0.04 ppm when
used according to recommendations. (See
“Range Specifications” section)
Ion Generation: Photo ionization of negative ions
Control Panel Indication: A) Power indicator light
B) Timer indicator light
C) Fan Speed indicator light
D) UV Lamp indicator light
Timer Control: [Continuous] or [ 2], [4] or [8] hour
Fan Control: Low Fan / Med Fan / High Fan
Lamp Life Monitor: 8,760 Hours
Remote Control: Infra Red 3-Key Remote Control
Remote Control Distance: 19 ft / 6 m maximum
Materials: ASA, Aluminum Composite
Power Cord: AC / DC transformer, “B” type - center pin “+”
Electrical Input: 12V DC
Certifications: Wall Adapter: UL, CE, CSA; Ballast: TÜV; Lamp: CE
Manufacturer’s Part Number: PR05, PR10, PR20, PR30
TROUBLESHOOTING
To Next Page
Loading...