BIRO 342 - Electrical Controls for 3, 5, 7 1; 2 Horsepower Grinders

IMPORTANT: Must have Model and Serial Number when ordering Parts
ELECTRICAL CONTROLS
3, 5 AND 7
1
2
HORSEPOWER GRINDERS
12
FROM SERIAL NO. 2250 TO
SERIAL NO. 5239
ORIGINALLY EQUIPPED WITH ALLEN BRADLEY
609-BAA MANUAL STARTER WITHOUT MAGNETIC
SAFETY SWITCH. THESE SWITCHES ARE OBSO
-
LETE AND MUST BE UPDATED TO THE APPRO
-
PRIATE AEG EQUIVALENT. ORDER H478AE
(SPECIFY HP AND VOLTS TO COMPLETE
NUMBER). AEG SWITCH ASSEMBLY MUST BE IN
-
STALLED BY A QUALIFIED BIRO SERVICE
AGENCY.
FROM SERIAL NO. 9039 TO
SERIAL NO. 11260
ORIGINALLY EQUIPPED WITH ALLEN BRADLEY
609U-BAA MANUAL STARTER WITH MAGNETIC
SAFETY SWITCH. THESE SWITCHES ARE OBSO
-
LETE AND MUST BE UPDATED TO THE APPRO
-
PRIATE AEG EQUIVALENT. ORDER H478AE
(SPECIFY HP AND VOLTS TO COMPLETE
NUMBER). AEG SWITCH ASSEMBLY MUST BE IN
-
STALLED BY A QUALIFIED BIRO SERVICE
AGENCY.
CONVERSION TO
AEG STARTER
FROM SERIAL NO. 2250 TO SERIAL
NO. 11260 WHEN REPLACING AN
ALLEN BRADLEY SERIES 609
STARTER WITH AN AEG STARTER.
NEW HOLE LOCATIONS MUST BE
DRILLED IN THE MACHINE CASE FOR
MOUNTING THE STARTER AND RE
-
LOCATING THE SWITCH ROD AS
SHOWN IN THE DIAGRAM.
14