EasyManua.ls Logo

Bison NB Series - SAFE OPERATION AND STORAGE PRACTICES

Bison NB Series
72 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Make sure that the implement is properly adjusted
and in good working condition.
The tractor must be equipped with ROPS cabin and
seat belt. Keep the safety belt properly secured.
Tractor rollover can result in death from being run
over or crushed. Keep folding ROPS systems in
"locked" position at all times.
Make sure all safety decals are installed, replace
any damaged or unreadable.
To transport the equipment be sure to have at least
20% of the total weight of the tractor and equipment
in the front shaft of the tractor wheels. Without this
weight, the tractor may roll over causing personal
injury or death. The weight can be obtained with a
front loader, front wheel counterweights, ballast
tires, tractor or front counterweights. Weigh the
tractor and equipment, do not estimate it.
Make sure the circuit lever control valve does not hit
the tractor cab, etc. throughout the operating range
of the tractor hitch box. Fold the lever, if necessary,
to clear the cockpit, but should still be convenient to
operate from the tractor seat.
OPERATION
Do not allow viewers in the area when operating,
removing, mounting or repairing the equipment. Do
not operate equipment under the influence of
alcohol or drugs.
Operate only in daylight or under good artificial light.
Keep hands, feet, hair and clothing away from
equipment while the engine is running. Stay away
from all moving parts.
Always follow all state and local lighting require-
ments.
Never allow riders on the tractor or implement.
The tractor must be equipped with ROPS or cab
and seat belt. Keep the safety belt properly secured.
Rollover tractor can result in death from being run
over or crushed. Keep folding ROPS systems in a
position to "lock" at all times.
Always sit in the driver's seat when operating the
controls or start the engine.
Securely fasten your seatbelt, put the transmission
in neutral, set parking brake, and ensure that all
other controls are disengaged before starting the
drive motor.
Look down and back and make sure the area is
clear before reversing machine.
Do not operate on steep slopes.
Do not stop, start or change direction suddenly on
slopes.
Be very careful and slow down on slopes and
difficult terrain.
Be aware of the dangers hidden in the ground
during the operation.
Leave the tractor and the implement immediately
when hitting an obstacle.
Stop engine, remove key, inspect and repair any
damage before resuming operation.
Before making manual adjustments for tilt or angle
positions:
Park tractor on level ground, apply the parking
brake, turn off the tractor and remove the key.
Make manual changes slowly and carefully to avoid
dangerous movements of the mechanisms.
Never stand in positions where you could be stuck
for setting changes or if the 3-point hitch suddenly
lowers.
(Safety rules continue on next page)
15
SAFETY RULES