Bison NB Series - TORQUE SCREW SPECIFICATION; BOLT TIGHTENING SPECIFICATIONS

61
GENERAL INFORMATION
Screws torque values.
Always replace bolts with others of the same grade. Metric screws have the class number
marked on the head.
Tighten the screws according to the table, unless otherwise indicated in operators manual.
Do not over tighten the screws, as this could cause failure during operation.
Note: DO NOT use these values if a different torque value for a specific application is
specified. The values given are for general use. Periodically check the tightening of the
screws.
TORQUE SCREW SPECIFICATION