4、Storage
Never store the machine with petrol in the fuel tank in a confined area with bad ventilation. Petrol
fumes could reach open flames, sparks and cigarettes etc.
If the machine is to be stored for a longer period than 30 days, the following methods are
recommended.
1. Empty the fuel tank.
2. Start the engine and let it run until it stops due to lack of fuel.
3. Change the engine oil if it has not been done for 3 months.
4. Remove the spark plug and empty a little engine oil (about 30 ml) in the hole. Crank the
engine
a couple of times. Screw back the spark plug.
5. Clean the whole machine thoroughly.
6. Lubricate all the parts as shown in LUBRICATING above.
7. Inspect the machine for damage, repair if necessary.
8. Touch up any paint damage.
9. Rust protection to the metal surfaces.
10. Store the machine indoors if possible.
Chapter Five Debugging Method of Power tiller
1、Debugging method of mesh of bevel gear
When the abnormal transmission of mesh of bevel gear
of sound is confirmed, stop the machine and check as
stipulated below:
1. Clearance adjustment of mesh of angel gear in gear-box
( See Figure 10)
① When lateral clearance of mesh of the gear
Italia Star Com Due S.R.L.
To Next Page
Loading...