How to fix Bissell POWERCLEAN 2494 Vacuum Cleaner that won't turn on?
If your Bissell Vacuum Cleaner won’t turn on, start by checking the electrical plug to ensure the power cord is properly plugged in. If it's plugged in, check your fuse or breaker. Replace the fuse or reset the breaker if needed.
What to do if Bissell POWERCLEAN 2494 tool won't pick up dirt?
If the tool on your Bissell Vacuum Cleaner isn't picking up dirt, there are several possible reasons: * Check the hose for any cracks or holes and replace it if needed. * Inspect the vacuum for clogs, looking for debris build-up in the inner tank, hose, and foot/lower hose. * Empty the Dirt Tank if it's full. * Ensure the Dirt Tank or upper tank is correctly positioned and locked in place. * Check the filters and clean or replace the pre-motor and post-motor filters if they are dirty.
Why is dirt escaping from my Bissell Vacuum Cleaner?
If you see dirt escaping from your Bissell Vacuum Cleaner, the Dirt Tank may be full; empty it. Also, check the pre-motor and post-motor filters to ensure they are installed correctly. Make sure that filters are not missing.
How to make Bissell POWERCLEAN 2494 easier to push?
If your Bissell Vacuum Cleaner is difficult to push, adjust the powerfoot to the correct height setting.
General| Type | Upright |
|---|---|
| Surface Recommendation | Carpet, Hard Floor |
| Model Number | 2494 |
| Power Source | Corded Electric |
| Voltage | 120 V |
| Included Accessories | Crevice Tool, Dusting Brush |
| Special Features | OnePass Technology |
Critical warnings to prevent hazards during operation and maintenance.
Avoid injury from moving parts while vacuum is on.
Turn off power and disconnect plug before maintenance.
Do not operate with damp or wet filters or without all filters.
Turn off power and disconnect plug before maintenance.
Turn off power and disconnect plug before clearing clogs.
To Next Page