Assembly Instructions
WARNING
Refer to the enclosed user guide for complete
instructions and important safety notices.
PROHEAT
®
QUICK START GUIDE
160-8122 01/16 RevB
PARTS INCLUDED
a. b. c. d.
e. g.
a. Upper Handle
b. Base
c. 3” Tough Stain Tool
d. Upper Hose Rack
e. Lower Hose Rack
f. Long Screws (2)
(taped to Upper Handle)
g. Short Screws (2)
(taped to Upper Handle)
f.
h.
i.
h. Nozzle Clean Out Tool
i. Trial-Size BISSELL Formula
1
2
1. The only tool you will
need to assemble your
deep cleaner is a Phillips
screwdriver.
2.
Slide Upper Handle (a.)
assembly onto lower body
and secure with two long
screws. These screws can be
found taped to the handle.
3. Attach the Upper Hose Rack
(d.) to the back of upper
handle by pushing into open
slots and sliding down until it
snaps into place.
1
2
4. Attach Lower Hose Rack (e.)
by sliding it in place on the
lower body assembly and
securing it with two short
screws.
5. Attach Tough Stain tool to
end of hose. Then wrap flex
hose around hose rack and
secure it into notched out
holder as shown.
1
2
To Next Page
Need help?
General
