Bissell Quickwash BS-1950F User Manual

Prepared by Monique Lania 1 Call Servicing Guide QuickWash
1950F.doc
Troubleshooting
Bissell Quickwash BS-1950F
CONTENTS PAGE
Consumer states the handle screw will not attach……………………..…….…Page 2
Consumer states unit will not spray……………..………………….…………..…Page 3
How to change (remove and fit) brush/bare floor attachment………………..Page 9
Consumer states no suction………………………………………………………...Page 10
The unit is not sucking while using bare floor tool………….………………….Page 11
Consumer states no power……..……………………………………………………Page 12
Consumer states the unit is leaking at the spray bar…………………………….Page 13
Consumer states the unit is very noisy…………………………………………….Page 14

Bissell Quickwash BS-1950F Specifications

General

Brand	Bissell
Model	Quickwash BS-1950F
Category	Vacuum Cleaner
Language	English

Summary

Bissell Quickwash BS-1950F Troubleshooting

Handle Screw Attachment

Steps to fix issues where the handle screw does not attach properly to the unit.

Unit Fails to Spray

Troubleshooting guide for resolving the problem of the unit not spraying solution.

Brush/Bare Floor Attachment Change

Instructions for removing and fitting brush or bare floor attachments.

No Suction

Diagnostic steps for when the unit fails to provide adequate suction.

No Suction with Bare Floor Tool

Specific troubleshooting for lack of suction when using the bare floor tool.

No Power

Steps to resolve issues where the unit does not turn on.

Leaking at Spray Bar

Procedure to address leaks occurring at the unit's spray bar.

Excessive Unit Noise

Explanation for unit noise and potential user-suggested remedies.