Need help?Do you have a question about the Bistos BT-350E and is the answer not in the manual?
General| Printer | Built-in thermal printer |
|---|---|
| Alarm | Audible and visual alarms |
| Paper Speed | 1, 2, 3 cm/min |
| Battery | Rechargeable lithium-ion battery |
| Parameters | FHR, TOCO |
Guidance on initial setup and essential checks before operating the fetal monitor.
General safety guidelines, warnings, and cautions for using the BT-350 fetal monitor.
Specific warnings and precautions related to electrical shock risks when using the device.
Guidelines for the safe operating environment, avoiding moisture, dust, and extreme conditions.
Specifies the intended purpose and application of the BT-350 fetal monitoring system.
Explains the technical method and process by which the fetal monitor operates.
Detailed labeling and identification of the various physical parts of the BT-350 monitor.
Explanation of the main monitoring screen layout and its different display frames.
Describes the monitor's self-test procedure upon power-on for system checks.
Explains how to use the control knob for navigating menus and adjusting system settings.
Instructions on how to save measured patient data on the monitor or USB memory.
Details the computerized diagnosis function for FHR and UC patterns.
Details the function and operation of the front panel buttons specific to the BT-350E model.
Lists and explains error and status messages displayed on the BT-350E monitor.
Explains how to use the control knob for system settings on the BT-350E.
Step-by-step guide on how to properly load paper into the printer tray.
Instructions for starting, stopping, and advancing the printer functionality.
Details the symbols and their meanings found in the printed FHR and UC traces.
Information on how to avoid or mitigate interference from electromagnetic fields.
Step-by-step guide for preparing and starting fetal heart rate monitoring.
Detailed instructions for explaining the monitoring procedure to the patient and probe setup.
Steps for preparing the monitor and acquiring uterine contraction data.
Detailed instructions for explaining the procedure and placing the UC probe.
Describes how patients can mark important events during monitoring.
Describes how doctors can mark important clinical events during monitoring.
Instructions for cleaning and disinfecting the main monitor unit.
Detailed procedures for cleaning and disinfecting the ultrasound and UC probes.
Provides acoustic output data and parameters for the transducer assembly.
Describes the self-test procedure for troubleshooting when the monitor turns on.
Steps to test the functionality of the ultrasound transducer.
Procedure for testing the functionality of the UC (TOCO) probe.
Recommended maintenance intervals for dielectric strength and leakage current testing.
Details compliance with standards for electromagnetic emissions.
Guidelines for maintaining safe distances from RF equipment to prevent interference.
Information on the BT-350's immunity to various electromagnetic tests.
To Next Page
