5. Monitoring Your Miner
To check the operating status of your miner:
1. Click Miner Status.
2. Under AntMiner, monitor your miner according to the descriptions in the following table:
Option Description
ASIC# Number of chips detected in the chain.
Frequency ASIC frequency setting.
GH/S(RT) Hash rate of each hash board (GH/s)
Temp(PCB) Temperature of each hash board (°C).
Temp(Chip) Temperature of the chips on each hash board (°C).
ASIC status One of the following statuses will appear:
● O - indicates OK
● X - indicates error
● - - indicates dead
AntMiner S9 Installation Guide
5. Monitoring Your Miner
- 13 -
To Next Page
Loading...