BIXOLON BCD Series - Extended Special Function Configuration; Supported Resolution Settings

BCD Series
Rev. 2.06
- 14 -
6-3 Extended Special Functions
“FontControlA” font is provided as an inherent special function. By using with a command
defined file (BCD.ini), you can designate a desired command string as the “FontControlA”
font arbitrary character (a character code with a range between 20 to 7F).
Details on how to use this are as follows: (Do not use “Read-only” file attribute.)
- FontControlA command defined file:
[File Name] BCD.ini
[Installation destination] The printer processor folder: The OS
System32\Spool\Prtprocs\W32x86 folder
- Description method:
Write descriptions similar to normal INI file format.
[Section Name]
Key_1=Data_1
Key_2=Data_2
Specify the Customer Display name as the section name.
E.g. [BCD-1000]
Specify each key in a hexadecimal character code corresponding to FontControlA font.
E.g. When “A” is specified for FontcontrolA font, write the key as 41=.
* The range that can be specified for each key is 20 to 7F.
Specify each data as a hexadecimal command corresponding to the character code
specified in FontcontrolA font.
E.g. When you want to send the initialization command (ESC @), write the data as 1B40.
- Sample description of an INI file:
[BCD-1000]
61=1F3AOC1F4500…
62=OC616263
6-4 Resolution
The resolution settings supported by BCD Character Type Driver are as follows
- 72  72
※ Note : In case of Character Type, graphic data is not displayed.