ATTACHING YOUR BIXPY K-1 MOTOR TO ADAPTERS
Your Bixpy K-1 motor has a four hole attachment point that is used to attached it to a variety of Bixpy Mounting
Adapters available at www.bixpy.com/adapters. The same attachment can be used to allow you to mount the
motor to your own (DIY) adapter. To secure your Bixpy motor to your adapter, open the provided M4 nuts and
bolts slide your adapter into the opening making sure the outlet of the motor is pointing to the rear of your
adapter. Use a Phillips screwdriver to secure the four nuts and bolts (DO NOT over tighten).
Use zip-ties and provided Bixpy Pipe Clips to secure the power cable to your adapter (not necessary for all
adapters) - see below.
Make sure there are no sharp kinks or bends in your wire on its way to your Bixpy Power Pack.
Page 5
Use the provided M4 nuts and bolts (1) to secure
your Bixpy motor to your Bixpy Adapter (2).
If you are making your own adapter for a DIY
application visit www.bixpy.info for instructions
and to download a template to make your own hole
patterns on your DIY receiver or adapter.
DO NOT over tighten your screws and
bolts as it may cause damage to the
adapter or standard attachment.
If you’re using your own hardware be
sure to use high grade stainless steel
fasteners to avoid corrosion.
1
1
2
To Next Page
Loading...