RUNNING YOUR MOTOR CABLES
Make sure your cables makes a clean exit out of your motor and around your adapter. Don’t make sharp bends
pull the cable or try to modify the cable in any way. Doing so may damage the signal wire cores inside and
prevent your device from running.
Page 6
If you are using a fin or rudder adapter simply run
the cable from your motor to your battery. Use
zip-ties or cords to secure your wire and prevent it
from dangling or snagging.
If you are using a Bixpy Adapter with a vertical pipe
you can use the provided Bixpy Wire Clips (1) and
zip-ties to secure the cable to your adapter pipe and
run the cable as far up the adapter pipe as you
desire before running it to your Bixpy Power Pack.
Additional Bixpy Wire Clips are available for
purchase at www.bixpy.com
1
To Next Page
Loading...