Labeling
Operating instructions GLP
2 -- 13
6.562.98.5.01.18
2.3.2 Subtraction from total memories in case of incorrect labeling
If packages have been incorrectly labeled, their price and weight may be subtrac-
ted from the total memories in different ways:
-- Reweigh weighed packages with the ”minus” function (see page 2 -- 24).
-- Subtract fixed value packages with the ”minus” function (see page 2 -- 23).
-- If a consecutive number is printed on the label, this number may be entered
and the article subtracted by calling the function ”cancel via numerator” (see
page 2 -- 22).
-- For several packages or cartons (boxes) the ”minus” function may be cal--
led up, the number of articles subtracted and their price and weight total ent-
ered in an editor and subtracted from the total memories. This is described in
section 3.5.6 from page 3 -- 103 onwards.
2.3.3
Labeling fixed price, fixed weight or fixed value packages
To label a larger number of fixed price, fixed weight or fixed value packages inde-
pendently of the labeler, the number of labels required may be entered and the
labels successively printed on the ejecting backing paper (see section 2.11.).
2.3.4 Labeling with the total preset per article
If a certain job total of an article is to be labeled, this total may be preset. During
labeling, the piece, weight and price totals of the articles labeled are continuously
compared with the preset job total. As soon as the preset total is reached, a mes-
sage to this effect will appear in the display (see section 2.7).
2.3.5 Labeling according to weight class (only for GLP with GT--CT)
In weight class--specific labeling, the weighed packages may be differently
labeled in relation to their weight and in accordance with the presettings of the
respective weight class (see section 2.8).
2.3.6
Labeling according to the weight class with the total preset (GLP+GT--CT)
If a total per weight class is also to be preset in weight class--specific labeling,
the necessary total may be entered for each weight class in a total preselection
matrix. As soon as the preset total of a weight class is reached, a message to this
effect will appear in the display (see section 2.8.5).
2.3.7 Tolerance check with statistics (only for GLP with GT--CT)
In conjunction with weight class labeling, a prepackaging control with statistical
evaluation (see section 2.9) is possible.
2
To Next Page
Loading...
