Labeling
Operating instructions GLP
2 -- 14
6.562.98.5.01.18
2.4 Preparing for labeling
2.4.1 Setting the weight display to zero
If a weight value is displayed although there is no weight applied to the load recep-
tor, the weight display may be set to zero within a preset range. Switching on the
device causes the weight display to be automatically set to zero.
As regards the GLP--PRIMA, zero setting is only possible with the device set
to ”auto. labeler
--
”.
Operating sequence: Description
------------------------------------------------------------------------------------------------------------------------------------------------------
-->0<--
-- Set the weight display to zero.
The appearance of this message after zero setting is an indication of a preset tare weight.
Close
Accept.
Process blocked:
For Zerosetting: Delete tare
window
Press “Accept.” if you want to cancel the text displayed and
enable the processing!
Tare
0 ENTER -- Enter zero as the tare weight (see page 3 -- 16).
--> 0 <--
-- Reset the scale to zero.
Tare
xx ENTER -- Reenter the tare weight (see page 3 -- 16).
The appearance of this message after zero setting is an in-
dication of a too high zero setting value.
Close
Accept.
Process blocked:
Scale outside range
window
-- Acknowledge the message. Withdraw any load from the scale
and reset it to zero.
2.4.2 Weighing the tare load
If the operating mode ”tare weighed” is set for the tare weight, the tare load must
be weighed (symbol above the tare softkey).
If the tare softkey is presented in grey, first set the unit to the release mode ’ma-
nual’ (see page 3 -- 65). Thereafter, make the previous presettings.
Operating sequence: Description
------------------------------------------------------------------------------------------------------------------------------------------------------
-- Place the packaging on the scale.
-- Tare the scale. The weight display is set to zero.
”NET” appears to the left of the weight value.
The tare weight remains stored.
2
Accept.
Accept.
Tare
To Next Page
Loading...
