Labeling
Operating instructions GLP
2 -- 25
6.562.98.5.01.18
2.7 Labeling with totals preset
If a certain job total is to be labeled for a customer, the relevant totals may be pre-
set as described from page 3 -- 112 onward and labeling carried out as described
in the following.
Example: 10 packages per box are to be labeled and 5 boxes are re-
quired.
Presetting for total 1: set ”Preset pieces” under ”type selection total 1”.
Enter the number/box under “Preset total *1” = 10.
Presetting for total 2: set ”Number total 1” under ”type selection total 2”. Enter
the number of boxes under “Number *1 in *2” = 5.
Procedure: -- Clear all total memories, if necessary (see page 3 -- 55).
-- Call the PLU data of the article (see section 2.1).
Check the article data displayed.
-- Weigh the packages and label them until the first batch
total is reached.
Total 1 reached: Total 1 reached appears in the display.
*1: 10
Total 1
reached
LB 21.5
Total label 1 is automatically printed
-- or print total label 1 manually and remove the same.
The display erases.
-- Continue labeling of batch total 1 until the grand total
preset (total 2) is reached.
Total 2 reached: Totals 1, 2 reached appears in the display.
*1: 10
Total 1+2
reached
LB 45.5
Total label 1 is automatically printed
-- or print total label 1 manually and remove the same.
The display erases.
-- Total label 2 is then automatically printed
[ETC]* -- or print total abel 2 manually and remove the same.
The display erases.
At the end of labeling: print other total labels, if desired (see section 3.4).
To label again
without total label
preset, clear the
amount preset for total 1 and total 2 (see page
3 -- 112).
2
Total 1
Total 1
Total 2
To Next Page
Loading...
