Labeling
Operating instructions GLP
2 -- 26
6.562.98.5.01.18
2.8
Labeling according to weight classes
(only for GLP with GT--CT)
2.8.1 Description
If the display and operating unit GT--CT is connected to the GLP and if weight
class--related labeling is activated at mode level 5, packages varying in weight
may be differently labeled in relation to their weight by calling up the relevant
weight class table together with the PLU data or via the relevant weight class num-
ber (see below). The weight class tables required for this purpose are usually
established at mode level 3 or 4, stored under the weight class numbers and assi-
gned to the relevant articles. There is also the possibility of calling up the weight
class tables directly at mode levels 1 and 2 and, if required, modifying them tem-
porarily for the actucal labeling procedure or restoring them permanently in the
database, provided that a relevant release is made at mode level 5 (see section
3.5.4 from page 3 -- 69 onwards).
2.8.2 Calling up weight class data manually
If weight class data is not called up automatically on PLU change, or in the event
that other weight class data is to be called up manually, a different weight class
number may be entered which permits the weight class data stored under this
number to be called up directly.
Operating sequence: Description
------------------------------------------------------------------------------------------------------------------------------------------------------
[MODE] 2
Labe--
ling
Weight cl.
statist.
[ETC]
class No.
-- Call up the input menu.
x x [ENTER] -- Enter the weight class number and acknowledge.
The presettings stored under the weight class number are loa-
ded.
The adjacent status message appearing after the input indica-
tes that a not yet existing weight class number has been ent-
ered.
Close
window
Weight. class No.:
No weight class data available
Close
window
-- Acknowledge the status message.
Load wgt.
class No.
-- Call up the input menu.
xxx [ENTER] -- Reenter a valid weight class number.
If the weight class data is stored under the PLU data, it will be over-
written on PLU change.
2
To Next Page
Loading...
