Labeling
Operating instructions GLP
2 -- 27
6.562.98.5.01.18
2.8.3 Labeling
-- Call the PLU data of article (see section 2.1).
-- Place the package on the scale.
Package is weighed and if the scale is stable a label is printed
according to the presettings in the respective weight class co-
lumn in relation to its weight.
-- Remove the package weighed.
-- Place the next package on the scale.
-- Remove the label from the labeler and affix it to the removed
package.
The total display permanently indicates
the number of labeled
packages, as well as their weight total (see page 3 -- 169 for
description).
If required, print total labels (see sec. 3.4)
2.8.4 Terminating weight class labeling
To label again without weight classes, the weight class number --1 may be ent-
ered. This causes the text in the display to disappear and weight class--specific
labeling to be terminated.
Operating sequence: Description
------------------------------------------------------------------------------------------------------------------------------------------------------
[MODE] 2
Labe--
ling
Weight cl.
statist.
[ETC]
class No.
-- Call up the input menu.
1 -- Enter weight class number 1.
[ +/-- ] -- Enter the minus sign.
[ENTER] -- Acknowledge input.
2.8.5 Labeling with the total preset per weight class
If a given total is to be labeled per weight class, this total may be input prior to
commencing labeling. The selection of the total type and the input of the relevant
total are described in section 3.6.1. A description of the labeling procedure is gi-
ven in section 2.8.3.
2
*1: # xx
kg xx,xxx
$ xxx,xx
<=
# xx
To Next Page
Loading...
