Labeling
Operating instructions GLP
2 -- 32
6.562.98.5.01.18
2.11 Printing a preset number of identical labels
If a larger number of fixed price, fixed weight or fixed value packages is to be labe-
led independently of the labeler, the number of labels required may be entered
and the labels successively printed on the ejecting backing paper.
If a number of labels has to be printed successively for several articles, a separa-
tion label may be output to make a distinction between the single printing jobs.
Since the printed labels remain on the backing paper, the light barrier responsible
for the removal of labels, must be switched off and back on.
Preparations
-- Cut the backing paper under the printer and let it exit the
labeler.
-- Set the labeling mode ”Fixed price”, ”Fixed weight” or
”Fixed value” (see page 3 -- 68).
-- Switch off the light barrier (see page 3 -- 66).
-- Set the unit to the label sequence mode ”With label se-
quence(+)” or ”Separation label” (see page 3 -- 67).
-- Enter the number of labels (see page 3 -- 67).
Printing the number of labels
[PRINT] -- Start label printing. The preset number of labels is prin-
ted and ejected on the backing paper.
[STOP] -- If required, stop the automatic printout of the preset num-
ber of labels using the STOP key.
-- Call the PLU data of the next article, if required and pre-
set the respective number of labels (see page 3 -- 67).
[PRINT] -- Start label printing for the next article, etc.
-- Cut the backing paper after the last printed label.
-- Affix the labels to the packages to be labeled.
-- Reinsert the backing paper (see page 2 -- 15).
At the end of labeling
-- Enter zero for the number of labels (see page 3 -- 67).
-- Switch the light barrier back on (see page 3 -- 66).
The preset number of labels is not reached:
In the event that an error occurs during printing of a label sequence and the preset
number of labels is not reached, printing may be continued after elimination of the
error cause.
[PRINT] -- Continue label printing.
2
To Next Page
Loading...
