Presettings for labeling
Operating instructions GLP
3 -- 47
6.562.98.5.01.18
3.3.4.8 Time/date 3
If the printout of time instead of the date is set (see page 3 -- 50), the use--by time
may be manually preset here.
Operating sequence: Description
------------------------------------------------------------------------------------------------------------------------------------------------------
[MODE] 2
Date Set date/
time
[ETC]
Time
Date 3
-- Call up the input menu.
xxxx [ENTER]
--
Enter the time of date 3 and acknowledge.
3.3.4.9 + days
With ”with + days” selected under the print data for date 3 (see page 3 -- 43), the
+days are printed out on the label in lieu of date 3.
If set accordingly, the +days (see below) called up directly with the PLU data may
be changed or directly preset if required.
If the +days are to be positioned above the PLU data, a relevant data interdepen-
dence must be set at mode level 5, e. g. D3=D2+H2. The shelf--life 2 stored under
the PLU data is then printed on the label as +days. In this case, the +days to be
printed may also be preset under shelf--life 2.
Operating sequence: Description
------------------------------------------------------------------------------------------------------------------------------------------------------
[MODE] 2
Date Set date
time
[ETC]
+ days
-- Call up the input menu.
xx [ENTER] or [ETC] -- Enter the new value and acknowledge or save in the da-
tabase (see page 1 -- 32).
3
To Next Page
