Presettings for labeling
Operating instructions GLP
3 -- 51
6.562.98.5.01.18
3.3.6 Date texts
3.3.6.1 Entering date texts
The input of the date texts is already described on page 3 -- 39 under ”date
texts”.
3.3.6.2 Presetting date text printing
Make the appropriate setting if a variable date text is to be printed on blank labels
in addition to date 1 and date 2. The procedure is described on page 3 -- 140.
3.4 Releasing the total
Accumulated totals may be printed on standard labels or preset customer--speci-
fic total labels whenever wanted (see section 3.6.4). There is also the possibility
of printing several total labels per total.
Clearing the total
For clearing total 1 and total 2, various alternatives are offered at mode level 5.
To clear the article and product group total, with or without deletion of the re-
spective total may be set at mode level 5 under ”Print total label”.
The remaining totals are cleared during printing of the daily total.
Total labels of totals 1 -- 3
If the articles labeled up to the printout of total 1, 2 or 3 are identical, the relevant
article text will be printed on the total labels (see label example of total 1 in sec-
tion 3.4.1).
If the articles labeled up to the printout of total 1, 2 or 3 are different and ”with
total text printing” is set as per page 3 -- 141, ”subtotal 1” will be printed on total
label 1, ”subtotal 2” on total label 2 and ”subtotal 3” on total label 3.
(see total 2 and total 3 label examples in sections 3.4.2 + 3.4.3).
Removing printed total labels
As regards semiautomatic labelers, the total labels are manually removed by the
operator. A light barrier detects the removal of label and the next single or total
label may be printed.
3
To Next Page
Loading...
