Operating conditions
Operating instructions GLP
1 -- 1
6.562.98.5.01.18
1 DEVICE
1.1 OPERATING CONDITIONS
To provide operational assurance, the requirements of these conditions have to
be met before commissioning and during operation of equipment.
The following conditions should be thoroughly read and strictly observed.
Contact us or your local after--sales service if any information is not properly un-
derstood.
1.1.1 General conditions
-- Transport and store equipment only in the original packing.
-- Do not install or start up equipment before the requirements of the Bizerba
operating conditions are met.
-- Do not commission, program, operate, clean and maintain Bizerba equipment
before supervising and operating personnel have thoroughly read and under-
stood the operating and programming instructions.
-- Hardware and software, tests and adaptation work which may become neces-
sary for external data dialogs between Bizerba equipment and peripherals are
subject to written approval from Bizerba.
--
For equipment from subcontractors supplied by Bizerba, the above instructions
apply equally unless they are contrary to the specifications of the manufacturer.
-- Use only genuine Bizerba wear and spare parts and accessories.
-- It is the responsibility of the user to submit the application for verification of the
equipment to the verifying authorities (see page 4 -- 14).
-- Packages arriving at the Bizerba conveyor belts or at the scale must be
free of any electrical charge.
.
Notes concerning GLP printer with Linerless label roll:
-- If the printer stands still for more than 30 minutes, the printhead
must be opened with the green knob to prevent the Linerless pa-
per from being stuck in the printer!
-- When cutting Linerless labels operating mode “with retract
operation” must be set (see page 3 -- 143).
1.1.2 Conditions applicable to the place of installation
-- Make sure that the surface on which the equipment is installed is level, and
vibration-- and draught--free.
-- Arrange the equipment in such a manner as to ensure optimal operation and
access for maintenance purposes (see section 1.3.1).
1.1.3 General instructions
-- Keep the labeler and the sclae clean and in a good operating state.
-- Maximum weighing accuracy is reached after a short warm--up period. It is ad-
visable to keep the device connected to the mains during working hours. This
ensures a constant operating temperature and thereby a maximum possible
weighing accuracy.
1.1
To Next Page
Loading...
