Operating conditions
Operating instructions GLP
1 -- 4
6.562.98.5.01.18
1.1.9 Warranty
Bizerba cannot accept any liability for damage resulting from
-- non--observance of our operating conditions and operating instructions.
-- installation by anyone other than Bizerba incorporated or designated repre-
sentatives.
-- faulty electrical connection by the user.
-- modification of our equipment in any way from its original form.
-- removal of verification seals and repair marks.
-- improper programming and operation.
-- failure to back up and protect data.
-- natural wear and tear.
Bizerba cannot accept any liability for damage resulting from work carried out by
anyone other than Bizerba--authorized representatives, the failure to use genuine
Bizerba replacement parts or ancillary means, especially when thermal labels
and ticket rolls are used which are not manufactured according to Bizerba specifi-
cation and which are not authorized by Bizerba.
When changing settings or reprogramming the equipment, always carry out
a test run and have a test record printed. This avoids unnecessary errors.
Ensure that only trained personnel operate the equipment. Take care to train per-
sonnel and ensure that they fully understand the operation of the equipment. Re-
peat training.
These instructions are subject to revision as further product development, expe-
rience and investigation may show is necessary or desirable. Graphics appearing
in these instructions may differ slightly from the model supplied due to country--
specific regulations.
.
When changing the software, compatibility with user--defined
softkeys, macros and setups is no longer ensured.
Thatiswhyallsuchsoftkeys, macrosandsetupsshould bechek-
ked and newly created if necessary.
1.1.10 Wireless LAN -- Device network
Wireless LAN are network solutions which enable a wireless connection of elec-
tronic devices.
The respective radio resource allocation regulations must be observed.
Warning
1. The Wireless hardware must be approved acordingly in each country where
the Wireless LAN network is set up.
2. The radiant power differs from country to country. It is set by law in the coun-
tries.
3. Bizerba cannot accept any liability for damage resulting from manipulation or
modification of the hardware or software of the network.
1.1
To Next Page
Loading...
