Operating conditions
Operating instructions GLP
1 -- 3
6.562.98.5.01.18
1.1.8 Safety instructions for labeler and packaging machine
Although labelers are equipped with all necessary safety
devices, failure to comply with the safety and warning notices
could result in serious bodily injury.
The labeler or the packaging machine should not be set into
operation before the supervising and operating personnel
have thoroughly read and understood the following safety in-
structions.
CAUTION!
-- Do not start or commission the labeler or the packaging machine until all in-
structions regarding operation and maintenance have been understood and
followed!
-- Keep fingers, hands, clothing or long hair out of reach of the moving parts of
the automatic packaging machine, such as conveyor belts, shafts, etc. while
the machine is in operation.
-- The operating personnel should wear suitable cloth which is unlikely to get
caught with moveable parts.
-- Do not deposit any object on the infeed conveyor belt of the packaging ma-
chine and do not use it for storage.
-- Unplug the main power supply of the automatic labeler before doing any clea-
ning.
-- To replace the label roll or clean the printer, the weigh--price labeler may be
opened.
-- Any other parts of the unit should only be opened by trained personnel or
service technicians. Before opening the unit, first disconnect the power
cable from the mains.
.
Never reach into the running conveyor belts or machine!
In case of danger switch the unit off by means of the
power switch!
.
Before removing a tray from the packaging machine or
the elevator, press the EMERGENCY OFF switch on the
infeed conveyor belt.
.
To ensure the accuracy of the scale, it must be horizon-
tally aligned at the place of installation!
.
The GLP must never be operated by turns in different sy-
stem networks !
1.1
To Next Page
Loading...
