Presettings
Operating instructions GLP
3 -- 127
6.562.98.5.01.18
3.6.8 Printing the secondary price total
The setting ”With print. o. secondary *” is only possible if ”Print. 2nd
price num. + code” is set (see page 3 -- 12).
In the event that a 2nd selling price is printed on single labels in the secondary
currency, the secondary price total formed on the basis of this 2nd selling price
may also be printed out on total labels.
Operating sequence: Description
------------------------------------------------------------------------------------------------------------------------------------------------------
[MODE] 2
Config.
total
[ETC] -- Call up the selection menu.
Print
sec. *
+
--
Select ”with(+)” if the secondary price total formed on the basis
of the 2nd selling price is to be printed on total labels.
Standard setting: without(--)
Label example:
Conversion rate
Primary price total
Secondary price total, e. g. in Euro
Additional printout of unit prices on total
labels (see page 3 -- 10)
Printout of weight unit on total labels (see
page 3 -- 12)
Printout of piece total in conjunction with
printout of unit price on total labels.
3.7 Labels
Prior to selecting the label type, the minimum font size required
for the intended use according to legal requirements is to be
taken into account, e. g. for prepackages having an identical
weight. Because of the font sizes required in relation to the nomi-
nal filling quantity, it might happen that standard labels cannot be
used.
3
To Next Page
Loading...
