Bizerba GLP 80 - Page 302

Presettings
Operating instructions GLP
3 -- 164
6.562.98.5.01.18
3.10 Print
3.10.1 Printing code strings 1--5 separately
Necessary presettings are described on page 3 -- 30.
3.10.2 Operator number
A prerequisite for printing an operator number is that ”with operator
number” be set and that no device number be entered.
If an operator number is to be printed on the labels, a relevant setting must be
made here (for entering the operator number, see page 3 -- 25).
Operating sequence: Description
------------------------------------------------------------------------------------------------------------------------------------------------------
[MODE] 2 [ETC]
Print
-- Call up the selection menu.
Operator
+
number
--
Preselect printing ”with(+)” or ”without(--)” operator number.
Standard: without(+)
3.10.3 DIGIT code
The digit code is only printed if ”without operator number” is set (see
section 3.10.2) and provided that no lot number is entered.
On single labels, a 3-digit code may be printed in the field of the device number.
It is composed of the 2--digit department number and the weighted check digit for-
med over the maximum 6--digit selling price and the maximum 2--digit department
number. Exceeding the number of preset digits prevents the digit code from being
printed. The department number is entered as the device number.
Operating sequence: Description
------------------------------------------------------------------------------------------------------------------------------------------------------
[MODE] 2 [ETC]
Print
-- Call up the selection menu.
DIGIT
+
code
--
Preselect ”with(+)” or ”without(--)” printing of the digit code on the
label.
Standard: without(--)
3