Presettings
Operating instructions GLP
3 -- 163
6.562.98.5.01.18
3.9.5.1 Setting counter 1
Counter 1 may be set to any initial start value as required.
Operating sequence: Description
------------------------------------------------------------------------------------------------------------------------------------------------------
[MODE] 2 [ETC]
Numer--
ators
[ETC]
Count.1
manipul.
Set
counter1
-- Call up the input menu
xx [ENTER]
--
Preset the value for counter 1 and acknowledge.
3.9.5.2 Package type for counter 1
This menu point permits the type of package to be set at which counter 1 is to
count. The counting event is preset under ”Counting event” (see below).
Operating sequence: Description
------------------------------------------------------------------------------------------------------------------------------------------------------
[MODE] 2 [ETC]
Numer--
ators
[ETC]
Count.1
manipul.
Pck.type
counter1
Call up the selection menu
Single
package
Make this setting if counter 1 is to count every time a single package
is processed (standard setting).
Total
1
Make this setting if counter 1 is to count on printout of total 1, e. g.
every time a carton is completed.
Total
2
Make this setting if counter 1 is to count on printout of total 2, e. g.
every time a pallet is completed.
Total
3
Make this setting if counter 1 is to count on printout of total 3, e. g.
every time an order is completed.
3.9.5.3 Counting event
This menu point permits the counting event to be preset at which counter 1 is to
count in relation to the package type selected (see above).
Operating sequence: Description
------------------------------------------------------------------------------------------------------------------------------------------------------
[ETC]
Numer--
ators
[ETC]
Count.1
manipul.
Count.
event
-- Call up the selection menu.
Never
Make this setting if counter 1 is not to count
(standard setting).
Print
logo 1
Make this setting if counter 1 is to be increased on the labels every
time logo 1 is printed out.
Example: counting of packages marked with the green point.
For this purpose, the green point must be stored and selected as
the logo 1 (see page 3 -- 34).
Each
package
Make this setting if counter 1 is to count every time a label is printed
for the package type selected (for single packages or total labels for
cartons, pallets etc.).
3
To Next Page
Loading...
