Status messages
Operating instructions GLP
4 -- 4
6.562.98.5.01.18
Cont.: other status messages
MESSAGE CAUSE REMEDIAL ACTION
Total deleted
-> below/above range
A value exceeding the
current total has been
subtracted in connection
with the minus function by
wastage weighing, calling
of fixed value articles or the
input of a piece, weight or
price total.
Range exceeded: Over-
flow because total memory
has not been cleared.
Print total 1 and total 2 prior
to next labeling procedure.
Activation not possible
-> min. limit violated
Input value smaller than
value permitted.
Reenter increased value.
Activation not possible
-> max. limit violated
Input value larger than
value permitted.
Reenter reduced value.
Weight type change
weight total cleared
When switching to a
different weight type the
weight total in the total
display has been cleared.
The content of the total
memories is retained.
Print daily total in order to
clear all total memories.
This causes the weight of
the new weight type to be
accumulated in the total
memories.
Price type change
price total cleared
The price total in the total
display has been cleared
during switching to
another country. The
content of the total
memories is retained.
Print daily total in order to
clear all total memories.
This causes the price to be
accumulated in the new
currency in the total
memories.
Module: 20 Euro
No licence for this function
OK <ENTER>
The appearance of the status message ”No licence for this function” indicates
that a softkey presented in grey has been activated the use of which is, however,
subject to the purchase of the licence module indicated.
The said function may only be activated by means of the licence module
indicated together with the status message, e. g. 20 EURO.
[ENTER] or [HOME] -- Acknowledge the message and clear it.
4.1
To Next Page
