Maintenance
Operating instructions GLP
4 -- 7
6.562.98.5.01.18
4.2 MAINTENANCE
4.2.1 Instruction on cleaning
The following cleaning instructions must always be observed.
Please clean the device components at the time intervals recommended
or if they are soiled by using the cleaning agents mentioned!
Unplug the main power supply before doing any cleaning!
Thoroughly cover and protect the equipment when cleaning the area
in which it is installed.
Do not use for cleaning:
>
sharp or hard objects
>
high- pressure washers
>
compressed air
>
detergents containing solvents which are dangerous to health
4.2.1.1 Cleaning process
1.
Cleanining display and operating unit
Frequency Cleaning agent
As required, but at
least once a week.
Soft, damp, lint--free cloth, non--scouring agents
GT- CT
Display and
operating unit
As required, but at least
once a week.
Soft, damp, lint--free cloth,
non--scouring agents
2. Cleaning printer
Frequency Cleaning agent
Printer
Printhead,
Tearoff edge
Depending on how strong
the soiling is, every time
the label roll is replaced,
but at least once a day
(see page 4 -- 8).
We recommend the use of the
BIZERBA cleaning agent for
thermal printheads (order No.
94008900077) or a cotton bud
soaked in spirit common in trade.
IMPORTANT: do not use any
label solvent, hard or sharp
objects.
Guide rollers Every time the label roll is
replaced, but at least
once a day (see page
4 -- 8).
Soft, lint--free cloth soaked in
commercial methylated spirits. If
heavily soiled, dismantle roller,
spray with label solvent and wipe off.
The instructions concerning the
handling of the label solvent must be
observed.
Pressure
rollers
Once a day. To clean the
printer as described on
page 4 -- 8.
Soft, lint--free cloth soaked in
commercial methylated spirits.
4.2
To Next Page
Loading...
