Installation and commissioning
Operating instructions GLP
1 -- 22
6.562.98.5.01.18
1.3.8.3 Switching the packaging and labeling unit off and on
Do
not
switch on the packaging machine before the operating
personnel have been thoroughly instructed on the operation and
safety/warning notices of the unit.
-- Before switching on, remove any tray from the infeed conveyor belt.
-- Keep the infeed conveyor belt free of foreign matter.
Switching on the machine
--
Switch on the packaging machine and the labeler by means of the main switch.
-- A test display appears, followed by the operator display.
-- Please refer to section 4.1 for the meaning and treatment of status messages
appearing in the display.
-- Preparing the unit for labeling, packaging and labeling are described in greater
detail in section 2.5.
Labeler GLP
Mains switch of labeler
on the labeler rear side
EMERGENCY--OFF
keyswitch arrangement
according to machine type
Main switch arrangement
according to machine type
If required, the labeler may be switched on or off by means of its mains switch at
the rear of the device independently of the packaging machine.
If the labeler is switched off and back on, it should be left switched off for approx.
5 seconds.
In case of problems arising during the conveying and packaging
procedure, stop the automatic unit via the EMERGENCY OFF
switch (see instructions of the packaging machine).
If the trouble recurs or in case of unusual noise switch the unit off
and contact your local after--sales service.
Keep the packaging machine and the surrounding area clean. Re-
gular cleaning and maintenance guarantee good performance and
a long service life.
1.3
To Next Page
Loading...
