AUTO Sweep
Selectable AUTO sweep provides sweep without trig-
ger input, automatically reverts to triggered sweep
operation when adequate trigger is applied.
Five Trigger Sources
Five trigger source selections, including CH 1, CH 2,
alternate, EXT, and LINE.
Video Sync
Frame (TV V) orLine (TV H)triggering selectablefor
observing composite video waveforms.TV-H position
can also be used as low frequency reject and TV-V
position can be used as high frequency reject.
Variable Holdoff
Trigger inhibit period after end of sweep adjustable.
Permits stable observation of complex pulse trains.
OTHER FEATURES
Bandwidth Limiter
Selectablefull bandwidth of 100mHz or limited band-
width of 20 MHz to filter high frequency noise from
low frequency waveforms.
X−Y Operation
Channel 1 can be applied as horizontal deflection
(X-axis) while channel 2 provides vertical deflection
(Y-axis).
Built-in Probe Adjust Square Wave
A 2 V p-p, 1 kHz square wavegenerator permitsprobe
compensation adjustment.
Channel 2 (Y) Output
A buffered 50Ω output of the channel 2 signal is
available at the rear panel for driving a frequency
counter or other instruments. The output is 50 mV/div
(nominal) into 50Ω.
Z-Axis Input
Rear panel Z-Axis input allows intensity modulation.
Supplied With Two Probes
FEATURES
4
To Next Page
Loading...
Need help?
General
