BK Precision 8601 - Page 58

58
MAXimum | DEFault ]
Returned Parameters
<NR3>
Related Commands
VOLT:VDR
[SOURce:] RESistance:LED[:STATe]
This command enables or disables the LED test selection in constant resistence mode.
Command Syntax
[SOURce:]VOLTage:LED[:STATe] <b>
Parameters
0 | 1 | ON | OFF
*RST Value
ON
Examples
VOLT:LED 1
Query Syntax
[SOURce:]VOLTage:LED[:STATe]?
Returned Parameters
0 | 1
[SOURce:]POWer
This command sets the power of the load when operating in constant power mode.
Command Syntax
[SOURce:]POWer[:LEVel][:IMMediate] <NRf+>
Parameters
0 to max. rated power
Unit
W (power)
*RST Value
MINimum
Examples
POW 5 POW:LEV 3.5
Query Syntax
[SOURce:]POWer[:LEVel][:IMMediate]?
Returned Parameters
<NR3>
Related Commands
POW:RANG
[SOURce:]POWer:RANGe
This command sets the power range of the load. This limits the settable range for power.
Command Syntax
[SOURce:]POWer:RANGe <NRf+>
Parameters
0 to max. rated power.
Unit
W (power)
Examples
POW:RANG 15 SOUR:POW:RANGE MIN
Query Syntax
[SOURce:]POWer:RANGe?
Returned Parameters
<NR3>