BK Precision 8601 Programming Manual

62
Related Commands
LIST:RANG
[SOURce:]LIST:SLEW
This command sets the slew rate for each step. This command programs both positive and negative
going slew rates. MAXimum sets the slew to its fastest possible rate. MINimum sets the slew to its
slowest rate.
Command Syntax
[SOURce:]LIST:SLEW <NR1>, <NRf>
Parameters
See specifications for range
Unit
None, None
Examples
LIST:SLEW 1, 1.5 LIST:SLEW 2, MAX
Query Syntax
[SOURce:]LIST:SLEW? <NR1>
<NR1> is step number
Returned Parameters
<NR3>
Related Commands
CURR:SLEW
[SOURce:]LIST:WIDth
This command sets the sequence of list dwell times. Each value represents the time in seconds that the
input will remain at the particular list step point before completing the step. If times exceed 16383S,
the input remains at the present level until a trigger sequences the next point in the list. Else At the
end of the dwell time, the input automatically changes to the next point in the list.
Command Syntax
[SOURce:]LIST:WIDth <NR1>, <NRf>
Parameters
20 us to 3600 s
Unit
s (seconds)
Examples
LIST:WID 1, 0.02 LIST:WID 2, 0.5
Query Syntax
[SOURce:]LIST:WIDth? <NR1>
<NR1> is step number
Returned Parameters
<NR3>
[SOURce:]LIST:SAV
This command stores the present list file of the electronic load to a specified location in memory. Up to
5 files can be stored. Files saved in locations 1-5 are nonvolatile and the data will be saved when power
is removed.
Command Syntax
[SOURce:]LIST:SAV <NR1>
Parameters
1 to 5

BK Precision 8601 Specifications

General

Brand	BK Precision
Model	8601
Category	Laboratory Equipment
Language	English