Black & Decker 9018-1 - Charger Mounting Instructions; Charging Notes

SWITCH
SPINDLE
LOCK KNOB
Charger Mounting
Instructions
(Figures 1 & 2)
1. The plastic bag supplied with your tool
contains two wood screws and two |
plastic wall anchors. Use the anchors
to mount the charger to drywall and
use the wood screws to mount itto a
wooden surface. (The charger need
BIT STORAGE
not be hung at all to operate properly.)
2. To use the plastic wall anchors drill a
3/16" hole in the drywall where you
will be installing the anchor. (Mark the
5. Hang the charger base vertically or
horizontally as shown in Figure 2.
6. Hank the extra cord so it's out of the
way. |
desired place by holding the charger
base against the wall and inserting a
pencil through one of the two
mounting holes.) Don't forget to locate
the charger base within 4 feet of a
wall outlet. The base is symmetrical
7 and cant be mounted upside down. `
3. Insert the plastic wall anchor and tap |
it lightly with a hammer to seat it flush
to the wall. Position the charger base
over the anchor and use one of the
wood screws to hold the charger base
on the wall. Repeat the process for
the other mounting hole in the charger —
base.
4. When mounting the charger base to a
wooden surface, drill 3/32" pilot holes
for the wood screws. The plastic wall
anchors should not be used when
hanging the charger base to a
wooden wall.
Charging Notes
NOTE: The Driver was sent from the
factory
in
an
uncharged
condition.
Before
attempting
to
use
it,
it
must
be
charged
for
12 hours.