EasyManua.ls Logo

Black & Decker BDC1A - Electrical Safety

Black & Decker BDC1A
116 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6
(Original instructions)
ENGLISH
Symbols on the charger
The following symbols are shown on the ap-
pliance along with the date code:
+
Warning! To reduce the risk of
injury, the user must read the
instruction manual.
p
Do not attempt to charge dam-
aged batteries.
$
The charger is intended for
indoor use only.
Electrical safety
#
Your charger is double insu-
lated; therefore no earth wire is
required. Always check that the
mains voltage corresponds to the
voltage on the rating plate. Never
attempt to replace the charger unit
with a regular mains plug.
u
If the supply cord is damaged, it must
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Features
This tool includes some or all of the following
features.
1. Charger
2. Charging indicator
Assembly
Warning! Before assembly, remove the battery
from the appliance/tool.
Fitting and removing the battery
u To t the battery, line it up with the receptacle
on the tool. Slide the battery into the receptacle
and push until the battery snaps into place.
u To remove the battery, push the battery release
button while at the same time pulling the bat-
tery out of the receptacle.
Use
Warning! Let the tool work at its own pace. Do not
overload.