7
ENGLISH
(Original instructions)
5. Recycle used batteries in accordance
with local regulations.
Assembly
Fitting and removing a screwdriver bit
(fig. B)
This tool uses screwdriver bits with a 1/4”
(6,35 mm) hexagonal shank.
1. To fit a bit, insert the bit shaft into the bit
holder (5) until it locks into place.
2. To remove a bit, pull the bit shaft out of
the bit holder (5).
Operation
Charging the battery (Fig. A)
• To charge the battery, insert the charger
plug (8) into the connector (9).
• Plug in the charger (7).
• Leave the tool connected to the charger
for 17 hrs.
The charger may hum and become warm
while charging; this is normal and does not
indicate a problem.
Warning! Do not charge the battery at
ambient temperatures below 10 °C or above
40 °C.
Before using for the first time
• Before first use, the battery must be
charged for 17hrs.
• The battery needs to be charged before
first use and whenever it fails to produce
sucient power on jobs that were easily
done before. When charging the battery
for the first time, or after a prolonged
storage, it will only accept an 80%
charge. After several charges and
discharge cycles, the battery will attain
full capacity.
Selecting the direction of rotation
For tightening screws, use forward
(clockwise) rotation. For loosening screws
use reverse (counterclockwise) rotation.
• To select forward rotation, push the
forward/reverse slider (2) upwards.
• To select reverse rotation, push the
forward/reverse slider (2) downwards.
• To lock the tool, set the forward/reverse
slider into the centre position.
Spindle lock
This tool is fitted with a spindle lock so that
it can be used as a normal screwdriver. Use
the tool this way to loosen very tight screws
or to firmly tighten screws.
Pivoting the tool head (Fig. C and D)
The tool is fitted with a tool head that can be
pivoted for optimum versatility.
• Push the pivot release button (3).
• Pivot the tool head to the inline position
(fig. D).
• Release the pivot release button (3).
Warning! Ensure the tool head is locked into
place before use.
Screwdriving
• Select forward or reverse rotation using
the forward/ reverse slider (2).
• To switch the tool on, press the on/off
switch (1).
• To switch the tool off, release the on/off
switch (1).
LED light
The LED light (6) is activated automatically
when the on/o switch (1) is depressed. The
LED light will also activate when the
forward/reverse slider (2) is set to the centre
position and the on/o switch (1) is
depressed.
Hints for optimum use
• Let the tool work at its own pace. Do not
overload.
• Always use the correct type and size of
screwdriver bit.
• If screws are difficult to tighten, try
applying a small amount of washing liquid
or soap as a lubricant.
To Next Page
Loading...
